PTFE Liner 3.5mm OD for heat break/throat - MP Select Mini V2* and Pro/V3 - (Qty 3)

MALYAN

Was: $7.25
Now: $6.20
SKU:
M200_V2-V3-PTFE-LINER
Maximum Purchase:
10 units
Bulk Pricing:
Buy in bulk and save

Bulk discount rates

Below are the available bulk discount rates for each individual item when you purchase a certain amount

  • Buy 1 - 1 and get 0% off
  • Buy 2 - 3 and get 5% off
  • Buy 4 - 5 and get 10% off
  • Buy 6 - 10 and get 15% off
PTFE Liner 3.5mm OD for heat break/throat - MP Select Mini V2* and Pro/V3 - (Qty 3)

Includes:

  • Three (3) PTFE liners measuring ~3.5mm O.D. x ~2mm I.D. x ~50.5mm - 51mm length

Not Included:

Compatible with:

  • Monoprice MP Select Mini V2 * (Please read below for more information)
  • Monoprice MP Select Mini "Pro"/V3

Please feel free to send an email if you are uncertain if these liners are compatible with your specific revision of the printer.

Compatible with the following models but would need to be cut to length:

  • Monoprice MP Select Mini V1 (PTFE liner would need to be cut to approximately 29mm)
  • Monoprice MP Mini Delta (PTFE liner would need to be cut to approximately 29mm)
  • Monoprice MP10 (PTFE liner would need to be cut approximately 44mm - 45mm)
  • Monoprice MP10 Mini (PTFE liner would need to be cut to approximately 44mm - 45mm)

* These PTFE Liners are meant to be used with heat breaks/throats that have an inside diameter of 3.5 mm which is what most revisions/batches of the printers mentioned above shipped with. Some early batches of Select Mini V2's (and possibly some batches since then) have heat breaks that have an inside diameter of 4.0 mm. If that is the case with your machine then you would need to use a PTFE liner with a 2 mm I.D. x 4 mm O.D. Please measure the inside diameter of your heat break or the outside diameter of the existing PTFE liner before purchasing this product. (Revisions is maybe not the correct term to use since it can often mean the change was an update and a permanent change but in these cases the change was temporary most likely due to the lack of availability of the heat breaks or maybe the 3.5mm OD PTFE.)