Includes:
- Three (3) PTFE liners measuring ~3.5mm O.D. x ~2mm I.D. x ~50.5mm - 51mm length
Not Included:
Compatible with:
- Monoprice MP Select Mini V2*
- Monoprice MP Select Mini "Pro"/V3
Compatible with the following models but would need to be cut to length:
- Monoprice MP Select Mini V1 (PTFE liner would need to be cut to approximately 29mm)
- Monoprice MP Mini Delta (PTFE liner would need to be cut to approximately 29mm)
- Monoprice MP10 (PTFE liner would need to be cut approximately 44mm - 45mm)
- Monoprice MP10 Mini (PTFE liner would need to be cut to approximately 44mm - 45mm)
These PTFE Liners are meant to be used with heat breaks/throats that are fully threaded with M6 threads.
* Please check to be sure that your heat break/throat has M6 threads on each end. This part may not compatible with the first two or maybe three batches of Select Mini V2's. Those batches had heat sinks that have M7 threads.