Heat Break / Throat - MP Select Mini V1 and MP Mini Delta

$6.35
(9 reviews) Write a Review
SKU:
HTBRK-30MM-SMOOTH
Maximum Purchase:
2 units
Shipping:
Calculated at Checkout

Description

Compatible with:

  • Monoprice MP Select Mini V1
  • Monoprice MP Mini Delta
  • Malyan M100
  • Malyan M200

9 Reviews Hide Reviews Show Reviews

  • 5
    Good product

    Posted by Unknown on Jun 9th 2019

    Works well.

  • 4
    Heat Throat / PTFE liner

    Posted by Erik Hansen on May 9th 2019

    Shipped quickly, came in as expected. The ptfe was a tad too long and protruded from the end of the throat. When I installed my nozzle, this bit got crushed and caused the filament to hang up leading to poor extrusion. I trimmed a bit off and it seems to be working fine now.

  • 5
    Excellent

    Posted by Andrew on Mar 19th 2019

    Excellent product exactly what i needed to fix my printer.

  • 5
    Exact OE replacement

    Posted by Andrew Y on Feb 20th 2019

    May have melted the Bowden tube in the heat break when I cranked up the temperature higher than I should have... Started having issues with the feeder skipping and filament kept getting jammed during or after a print. Replacing the heat brake resolved all my issues. Ended up putting a thin layer of heat transfer paste (same stuff you'd use on a CPU) on the contact points between the heat brake and heat sync to help keep the heat brake cooler.

  • 5
    this is the stuff

    Posted by Mark on Oct 7th 2018

    Parts from Gigdigit made my printer new again! Other parts from Amazon did not work so well.

  • 5
    Exact Replacement

    Posted by David on Sep 8th 2018

    After trying many other solutions ranging from replacing my melted inner liner to an all metal hotend, the solution to all my woes was a new stock heat break. It's the same exact one that comes stock with the printer.

  • 5
    Works great

    Posted by Chris Riley on Jun 19th 2018

    Fits my mini delta just great!

  • 4
    Solved some extrusion problems

    Posted by Matt on May 9th 2018

    I replaced the heat breaks on two V1 minis that had started to jam when printing, and it really improved matters. I ordered a couple of extras, which was fortunate because one of these turned out to be too large to fit into the heat sink.

  • 5
    MP Mini Delta Heat Break

    Posted by Todd Naber on Mar 30th 2018

    I needed the MP Mini Delta Heat Break after a recent Filament Plug-up. The teflon tube in the Heat Break ended up melting and the Throat became difficult to re-install in the block... so I ordered a replacement. Fortunately the replacement was available and it arrived quickly from California. I wish a 'Spare Parts Bag' was available for the MP Mini Delta... otherwise its nice to get hard to find OEM parts that keep me from using the printer!