Heat Bed with Silicone Wire (~17 - 18") - BLEMISH - MP Select Mini V1 and V2

MALYAN

Was: $25.50
Now: $23.50
SKU:
M200-BED-BLEMISH
Shipping:
Calculated at Checkout

THE BED WILL HAVE SMALL IMPERFECTION(S) OR SCRATCH(ES). THE BLEMISH(ES) ARE SUPERFICIAL AND WILL NOT HAVE ANY NEGATIVE EFFECT ON PRINTING.

This Compatible with:

  • Monoprice MP Select Mini V1
  • Monoprice MP Select Mini V2
  • Malyan M200

Would you like insulation installed? 
If yes, then be sure you choose the Bed Insulation option.

Wire sizes:
     • Heater Wire (with plug/connector) - A pair of 18-gauge silicone wires with a length of approximately 17 - 18 inches (34 - 36 inches total)
     • Sensor Wire (with plug/connector) - A pair of 24-gauge silicone wires with a length of approximately 17 - 18 inches (34 - 36 inches total)

The stock wire length is ~13.5 - 14 inches. The reason this bed comes with a few more inches is to make it easier to route the wires either through the back or the side of the printer's base.

IMPORTANT NOTES:

  • If you are purchasing this replacement heat bed because your current bed is warped and you are hoping for better luck with a new bed, please know that these heat beds are factory replacements. What I mean by this is that the beds are flat right now but there is no guarantee that they will not warp. The beds are approximately 1.5mm thick aluminum with a PCB heater built-in so there is a good chance some warping will occur.
  • Does NOT include the black build surface but can be purchased here - Build Surface - 129mm x 140mm - MP Select Mini V1/V2
  • Bed insulation included only if the option is chosen